STL file Vif D'or HARRY POTTER 🎨・3D printing idea to download・Cults

This vif d'or is made up of three parts: the body/sphere, the right wing and the left wing in symmetry. Print parameters : Sphere : - Materials: ABS (for acetone smoothing) - Layer thickness: 0.12 mm - Filling: 20 - Contour/perimeter shells: 3 (For good surface finish after acetone smoothing) - Generate a small area of support under the gold snapper for good printing. Wings: - Materials: ABS - Nozzle diameter: max 0.4 mm (Modify the extrusion width parameter (max 0.4 mm) if the feather hooks do not print) - Layer thickness: 0.2 mm - Filling : 100 -------------------------------------------------------------------------------------- Post treatment : Sphere : - Remove supports, deburr if necessary - Place in oven to smooth outer surfaces - Sand lightly if any areas remain unsmoothed - Paint the sphere with gold paint. I used gold spray paint. Wings: - Deburr if necessary - Lightly sand both sides - Heat the front structure with a hair dryer to give it the desired curvature. - Paint the wings Finally, assemble and glue the two wings to the sphere in the holes provided. Drill the holes to the correct diameter if necessary. ___________________________________________________ This snitch is made up of three parts: the body / sphere, the right wing and the left wing in symmetry. Print settings : Sphere: - Materials: ABS (for acetone smoothing) - Layer thickness: 0.12mm - Filling: 20% - Contour / perimeter shells: 3 (For a good surface condition after smoothing with acetone) - Generate a small area of support under the snitch for a good impression. Wings: - Materials: ABS - Nozzle diameter: max 0.4 mm (Modify the extrusion width parameter (max 0.4 mm) if the feather grips do not print) - Layer thickness: 0.2 mm - Filling: 100% -------------------------------------------------------------------------------------- Post-processing Sphere: - Remove the supports, deburr if necessary - Put in an oven to smooth the exterior surfaces - Lightly sand if there are non-smooth areas - Paint the golden snake sphere. I used gold spray paint. Wings: - Deburr if necessary - Lightly sand both sides - Heat the front structure with the hair dryer to give it the desired curvature. - Paint wings Finally, assemble and glue the two wings on the sphere in the holes provided for this purpose. Drill the holes to the correct diameter if necessary.

Simple Harry Potter logo

Harry Potter HP

STL file Vif D'or HARRY POTTER 🎨・3D printing idea to download・Cults

mate harry potter 3D Models to Print - yeggi

Free STL file Mate Harry Potter 🧉・3D printer model to download・Cults

Harry Potter best STL files for 3D printer・2.6k models to download・Cults

support baguette harry potter 3D Models to Print - yeggi

Harry Potter Shelf for Harry Potter FUNKY-POP from Kinder Joy by Duffy, Download free STL model

Free STL file Mate Harry Potter 🧉・3D printer model to download・Cults

STL file Harry Potter Mate and Mug 🧉・3D printable design to download・Cults