Toolbox Foam Insert - Gallery - Carbide 3D Community Site

Finally tackled a project I’ve had on my mind for about 5 years, ever since I got a laser cutter/engraver. Funnily, the Shapeoko beat the laser to the punch. Bought some 1.7pcf 1" thick foam sheets (arrive flat, not rolled), and stuck them down to the bed with double sided foam after cutting to size with a box knife. I ran my router near the top of the RPM range, and tried a few different feedrates though didn’t notice a huge difference. Got the best results using a 201 for large pocket

Ships wheel designed with Fusion 360 - Gallery - Carbide 3D

Community Challenge #27: Letter cut-outs (and so long) - Contests

For those with a 4X4 Shapeoko 5 Pro - Table questions - Shapeoko

Community Challenge #27: Letter cut-outs (and so long) - Contests

NTD: Starting as a helper in a fleet shop. I did what I could with

For those with a 4X4 Shapeoko 5 Pro - Table questions - Shapeoko

Sometimes I'm really impressed - Shapeoko - Carbide 3D Community Site

Toolbox Foam Insert - Gallery - Carbide 3D Community Site

Community Challenge #27: Letter cut-outs (and so long) - Contests

Tool tracing for organizers - Carbide Create - Carbide 3D

Topographic Map Box - Gallery - Carbide 3D Community Site

Topographic Map Box - Gallery - Carbide 3D Community Site

Topographic Map Box - Gallery - Carbide 3D Community Site

Milwaukee PACKOUT 16 in. Portable Modular Tool Case with Foam