Heavy Wall Adhesive Heat Shrink, 1' Lengths

Correctly using heat shrink is easier than you may think. Once you have selected the correct type of heat shrink whether it be 2-to-1, 3-to-1, or heavy wall, you should cut it to the proper length so that the body of the heat shrink straddles the connection point and fully covers the conductors. Once ready apply steady heat from a safe distance and continually move your heat source to prevent burning. If you apply too much heat to the heat shrink it may bubble or burn. By staying at a safe distance, you can completely activate the heat shrink without burning it. Additionally, too much heat can damage the insulation of the wire or cable you are working with. This is why keeping a safe distance is so imperative. If you are using epoxy-lined heat shrink, which we highly recommend, you will see the melted epoxy flow out creating an environmental seal. With your heat shrink properly activated, you are ready to move on to another project. All of the heat shrink and tools that you have seen here are available at . Where you’ll find over 9,000 high-quality electrical products.

Heat Shrink Tubing Heavy Wall Adhesive Lined Dual Wall

Kable Kontrol® 4:1 Adhesive Lined Heat Shrink Tubing - Dual Wall

Heat shrinkable tubing 6:1, adhesive lined in 1.2 m cuts HA67-44.4/7.4 (321-30200)

Our heavy wall adhesive lined heat shrink tubing is ideal for direct burial of heavy duty electrical cables, where environmental protection is necessary. This high quality heat shrinkable tubing is supplied with an inner adhesive layer, adding a water tight seal to the strain relief the tubing provides. When exposed to heat (usually a bit lower than the activation temperature of the heat shrink), the inner layer begins to flow (just like a hot melt glue).

7.1 Heat Shrink Tubing Heavy Wall Adhesive Lined 3:1 Ratio | 4 ft | BuyHeatShrink

ThermoShrink HeavyWall Heat Shrink 18 Length 5001000 MCM

1 inch (Diameter) 3:1 Dual Wall Adhesive Heat Shrink Tubing, Large Glue Lined Marine Cable Sleeve Tube, Premium Wire Wrap Protector for DIY by MILAPEAK (4 Feet, Black) : Industrial & Scientific

H-5(3X)-F Thin-wall heat shrink tubing, 3:1, With adhesive

National Standards Parts Products - Pacer Group

Kable Kontrol® 3:1 Dual Wall Heat Shrink Adhesive Lined Heat Shrink Tubing Sticks