It’s not much, but it’s a start. I had a hard time with the Oramask, so I went with just painting and then doing a .005 skim cut and it worked pretty well. Will use as a lazy susan on the table during Christmas season. I do want to figure out how to make the Oramask adhere better. Is there a downcut V-bit available? It would help if the bit wasn’t pulling the masking up during the cut.
Post up them failures - Gallery - Onefinity CNC Forum
Crooked ProjectHelp! - Onefinity CNC Forum
Troubleshooting A Carve - Onefinity CNC Forum
Help! Journeyman Homing issues - #22 by Mark - Troubleshooting (X35/X50) - Onefinity CNC Forum
Crooked ProjectHelp! - Onefinity CNC Forum
Error keeps popping up - Troubleshooting (X35/X50) - Onefinity CNC Forum
Is it possible to tram X/Y squareness with fixed feet? - Troubleshooting (X35/X50) - Onefinity CNC Forum
Machine stops once cut is in progress - Troubleshooting (X35/X50) - Onefinity CNC Forum
Is it possible to tram X/Y squareness with fixed feet? - Troubleshooting (X35/X50) - Onefinity CNC Forum
New project. Tree frames - Gallery - Onefinity CNC Forum
Post up them failures - Gallery - Onefinity CNC Forum
Lots of Wonderful Signshas anyone used their CNC for something other than signs? - Finished Projects - Onefinity CNC Forum
V1 Engineering Inc -V1E.com
Crooked ProjectHelp! - Onefinity CNC Forum
Machining fixtures making short-run production a piece of cake - Onefinity CNC Forum